Telecom Behnke 20-0001B-IP Anleitung Seite 47

Optional: If more than one module with buttons
and nameplate or just with buttons is used, the
module panels are connected to each other as
shown in the sketch below.
*included in the scope of delivery of the
corresponding module.
Place the electronics box on its front frame
5
incl. the screwed module housing.
www.behnke-online.de
Instructions for Behnke 20-0001B-IP, 20-0014B-IP, 20-0016B-IP
Connecting cable*
First put the module housing cover and then
the electronics box back onto the module
housing. Module housing cover omitted for
20-0014B-IP.
Please ensure that no connecting cables are
pinched during installation. Fix the connection
cables e.g. with a cable tie and install them in
the module housing.
Step 2:
Snap the elec-
tronics box into
place
"Click"
Step 1: Snap the module hous-
ing cover into place
6 Connect the intercom station to the net-
work (cf. from page "3. Basic electronics" on
page 50) and mount into the accordingly
prepared housing or column.
GB
Mounting
47