Zodiac EiSalt 12 Montage- Und Gebrauchsanleitung Seite 26

3. SAFETY WARNINGS AND RECOMMENDATIONS:___________________________________
-The equipment should be assembled and handled by truly qualified people.
-Current electrical and accident prevention regulations should be followed.
-Under no circumstances will the manufacturer be held responsible for the assembly, installation
or start-up, nor any handling or fitting of components unless they are carried out on its premises.
-The salt electrolysis systems operate at 230VAC, 50/60 Hz. Do not attempt to alter the system to
operate at a different voltage.
-Check that all the electrical connectors are well tightened to avoid false contacts and their
consequent overheating.
EN
-This device is equipped with a cable that has a ground conductor. The equipment must be
powered from a residual current device, which does not exceed 30mA (RDC). The equipment
must be electrically grounded.
-Before installing or replacing any component, disconnect the equipment from the mains, and use
exclusively spare parts supplied by the manufacturer.
-If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or
by qualified personnel in order to avoid a danger.
-Taking into account the fact that the equipment produces heat, it must be installed in places with
sufficient ventilation. Fan openings should be kept free of any element that could obstruct them.
The equipment should not be installed near flammable materials.
-The salt electrolysis systems have an IP24 protection degree. They should never be installed in
places susceptible to flooding.
-This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge and they have been
given sipervision or instruction concerning use of the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
Warning: For the electrical connection it is necessary to incorporate a disconnector switch that
ensures the omnipolar cut, directly connected to the power terminals and must have a contact
separation at all its poles, which provides total disconnection under overvoltage conditions of
category III, in an area that complies with the site safety requirements.
26