Zodiac EiSalt 12 Montage- Und Gebrauchsanleitung Seite 36

5. OPERATION:_________________________________________________________________
5.1. System on stand-by
The system goes into "STAND-BY" when the POWER SELECTOR" [2] key is successively pressed
until the "0%" light blinks. When this occurs, there is no production in the electrolysis cell.
EN
5.2. Production level selection
To select the desired production level, press the "POWER SELECTOR" [2] keys until the production
level light blinks. The system will set its production to the desired level after a few seconds.
The production setpoint could be visualized at any time by pressing once the "POWER SELECTOR"
key.
The light corresponding to the programmed production level will blink for a few seconds.
Fig. 12
Fig. 13
36