Herunterladen Inhalt Inhalt Diese Seite drucken

Assembly; Insert And Connect Battery - VOSS.farming Sunny 200 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für Sunny 200:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
7.1

INSERT AND CONNECT BATTERY

1. Place the device on a flat surface with the solar module (9) facing down and use a screwdriver
to remove the screw on the battery compartment lock (12).
N OT IC E
Make sure that there are no objects on the lying surface so as not to damage the
solar module.
2. Turn the device over, open the battery compartment (11) and insert the battery.
3. Connect the red cable (+) to the positive terminal of the battery.
4. Connect the black cable (-) to the negative terminal of the battery.
5. Close the battery compartment (11) again and screw the previously removed screw back into
the battery compartment lock (12).
7.2

ASSEMBLY

WA R N IN G AGA I N ST E LECTRICAL VOLTAG ES
Do not lay PVC cables at a temperature below +5°C.
N OT IC E
Make sure that the device is securely placed during assembly. The device must
later be operated upright with the device lid closed.
Select a mounting location, taking into account the general safety instructions, that meets the
following criteria:
next to the electric fence and preferably near the center of the electric fence
where the most amount of sunlight is reached in the season
where a good grounding can be achieved
on solid ground away from possible flooding and out of reach of animals and children
(inside the protective fence if necessary)
I nfo
Direct the device so that the module surface faces south in the northern hemisphere or
north in the southern hemisphere.
Mounting on wooden post or wall
For mounting on a wooden post or wall, you will need suitable nails
or screws and washers.
1. Fasten the nails or screws at a distance of 205 mm (Fig. 1).
2. Insert the nails or screws so that they protrude by 10 mm (Fig. 1).
3. Place the energiser with the hangers (5 & 8) on the nails or screws
so that the washers are inside the hanger.
Mounting on Y- or T-posts
The electric fence unit can be attached directly to a metal Y- or
T-post via the mount (6).
To do this, push the upper end of the post into the mount (6) on
the underside of the electric fence unit (Fig. 2).
30
INSTRUCTION MANUAL VOSS.FARMING SUNNY 200
Fig .1
Fig .2
42082 - 01.2022 - V5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

42082

Inhaltsverzeichnis