Rise MAX.CP Installationsanleitung Seite 16

Enables or disables programmable code transmitters.
On: Radio receiver enabled exclusively for rolling-code transmitters.
Cvar
Off: Receiver enabled for rolling-code and programmable (self-learning and dip/
switch) transmitters.
Enables or disables remote switching of radio transmitters (see REMOTE LEARNING
section).
REM
On: Remote entry enabled
Off: Remote entry disabled
MENU
Selecting this function, the receiver waits (Push) for a transmitter code to be assigned to the step-step function for bollard 1.
Press the key of the transmitter you want to assign to this function.
PP1
If the code is valid, it is stored and the message OK is displayed.
If the code is not valid, the message Err is displayed.
Selecting this function, the receiver waits (Push) for a transmitter code to be assigned to the step-step function for bollard 2.
Press the key of the transmitter you want to assign to this function.
PP2
If the code is valid, it is stored and the message OK is displayed.
If the code is not valid, the message Err is displayed.
Selecting this function, the receiver waits (Push) for a transmitter code to be assigned to the OPEN function (both bollards)
Press the key of the transmitter you want to assign to this function.
OPEN
If the code is valid, it is stored and the message OK is displayed.
If the code is not valid, the message Err is displayed.
Selecting this function, the receiver waits (Push) for a transmitter code to be assigned to the CLOSE function (both bollards)
Press the key of the transmitter you want to assign to this function.
CLOSE
If the code is valid, it is stored and the message OK is displayed.
If the code is not valid, the message Err is displayed.
Selecting this function, the receiver waits (Push) for a transmitter code to be deleted from the memory
CLR
If the code is valid, it is deleted and the message OK is displayed.
If the code is not valid or not stored in the memory, the message Err is displayed.
Completely deletes the memory of the receiver. Confirmation of the operation is requested.
RTR
When this function is selected, the receiver waits (Push) for a new PGM to confirm the operation.
At the end of the deletion, the message OK is displayed.
Displays the number of complete cycles (descent+ascent) performed by the M1 bollard. The first press of the <PG> button displays
the first 4 digits, the second press the last 4. Ex. <PG> 0012 >>> <PG> 3456: 123,456 cycles made.
Displays the number of complete cycles (descent+ascent) performed by the 2 bollard. The first press of the <PG> button displays the
first 4 digits, the second press the last 4. Ex. <PG> 0012 >>> <PG> 3456: 123,456 cycles made.
RESET of the control unit. WARNING!: Resets the control unit to default values.
Pressing the <PG> button for the first time causes the RES message to flash; pressing the <PG> button again resets the control unit.
Note: The transmitters are not deleted from the receiver, nor is the access password.
All logics and parameters are reset to default values, so the autoset procedure must be repeated.
16
RADIO (RAD)
MANOEUVRES NUMBER (Nma1)
MANOEUVRES NUMBER (Nma2)
RESET (RES)
FUNCTION
(ON)
(ON)