Important Safety Instructions; Fcc Statement - Anker A2540 Bedienungsanleitung

EN
LED Indicator Status
Solid white for 4 seconds,
Connected to power
then turns off
Solid white Charging your phone
•Metal objects detected
•Incompatible AC adapter connected,
Flashing
• You cannot charge your device wirelessly when using an
•
ultra-thick (> 4 mm) protective phone case or a case with a
T
pop socket.
• • This wireless charger only supports the protective cases that
match the magnetic structure of the iPhone.
• • Connect the wireless charger to a Quick Charge 2.0/3.0 or
Power Delivery wall adapter. Do not connect to a 5V/1A wall
charger or a USB port on a computer as it may affect the
wireless charging function.
• • Do not place any foreign objects between your device and
the wireless charger's surface, including metal pads on a
car mount, magnetic cards, door keys, coins, NFC cards or
other metal objects, as they could potentially demagnetize
the wireless charger, affect the charging speed, or cause
overheating.
• • Wireless chargers make charging more convenient than
wired chargers, but confined by current wireless technology,
their charging speed is slower than that of wired chargers.
• • High temperatures will reduce charging speed and restrict
power. It is recommended that you charge your device in
environments with temperatures below 35°C / 95°F.
01
indicating that you need to switch to a
Quick Charge 2.0/3.0 or Power Delivery
adapter

Important Safety Instructions

Please refer to the electrical and safety information on the
bottom before installing or operating the product.
•Avoid dropping.
•Do not disassemble.
•Do not expose to liquids.
•For the safest and fastest charge, use original or certified
cables.
•This product is suitable for moderate climates only.
•The maximum ambient temperature during use of this
product must not exceed 40°C.
•Open flame sources, such as candles, must not be placed on
this product.
•Only use a dry cloth or brush to clean this product.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and
receiver. (3) Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. (4) Consult the dealer or
an experienced radio / TV technician for help.
02