Important Safety Instructions - Anker 7-Serie Bedienungsanleitung

Specifications
Cell Capacity 2048 Wh
AC Input Voltage 220-240V~ 10A Max, 50Hz
AC Input Power (Charging) 2200W Max
Solar Panel Input 11-32V
Car Charger Output 12V 10A
AC Output 230V~ 10A, 50Hz, 2300W Max
USB-A Output 5V 2.4A (2.4A Max Per Port)
USB-C Output (100W) 5V 3A/9V
UPS 20ms
Discharging Temperature -4°F-104°F / -20°C-40°C
Charging Temperature 32°F-104°F / 0°C-40°C
Size 20.7 × 15.5 × 9.8 in / 52.5 × 39.5 × 25.0 cm
Net Weight 67.2 lb / 30.5 kg
Attention
Not permitted on aircraft.

IMPORTANT SAFETY INSTRUCTIONS

WARNING - When using this product, basic precautions should always be followed, including the following:
• Read all the instructions before using the product.
• To reduce the risk of injury, close supervision is necessary when the product is used near children.
• Do not put fingers or hands into the product.
• Do not expose the product to rain or snow.
• Use of an attachment not recommended or sold by the product manufacturer may result in a risk of fire,
electric shock, or injury.
• To reduce the risk of damage to the electric plug and cord, pull the plug rather than the cord when
disconnecting the product.
• Do not use the product in excess of its output rating. Overload outputs above rating may result in a risk of fire
or injury.
• Do not use the product or attachment that is damaged or modified. Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion, or risk of injury.
• Do not operate the product with a damaged cord, plug, or output cable.
• Do not disassemble the product. Take it to a qualified service person when service or repair is required.
Incorrect reassembly may result in a risk of fire or electric shock.
• Do not expose the product to fire or high temperatures. Exposure to fire or temperatures above 130°C may
cause explosions.
• To reduce the risk of electric shock, unplug the power pack from the outlet before attempting any instructed servicing.
• Have servicing performed by a qualified repair person using only identical replacement parts. This will ensure
that the safety of the product is maintained.
• When charging a device, the product may feel warm. This is a normal operating condition and should not be a
cause for concern.
07 EN
10A; 32V-60V 20A (1000W Max)
3A/15V 3A/20V 3A/20V 5A (100W Max Per Port)
• When charging the internal battery, work in a well-ventilated area and do not restrict ventilation in any way.
• Do not clean the product with harmful chemicals or detergents.
• Misuse, dropping, or excessive force may cause product damage.
• When disposing of secondary cells or batteries, keep cells or batteries of different electrochemical systems
separate from each other.
• Do not use or store the power station in direct sunlight for a long period, such as in a car, cargo bed, or any other
place where it will be exposed to high temperatures. Doing so may cause the product to malfunction, deteriorate,
or generate heat.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
• Disposal of a battery into a fire or hot oven, or mechanically crushing or cutting off a battery, can result in an explosion.
• Leaving a battery in an extremely high-temperature environment can result in an explosion or leakage of
flammable liquid or gas.
• A battery subjected to extremely low air pressure may cause an explosion or leakage of flammable liquid or gas.
• Unplug the AC power cable to disconnect from the line voltage.
WARNING: GROUNDING INSTRUCTIONS
This product must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least
resistance for electrical current to reduce the risk of electric shock. This product is equipped with a cord with an
equipment grounding conductor and a grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
WARNING – Improper connection of the equipment grounding conductor may result in an electric shock. Check
with a qualified electrician if you are in doubt as to whether the product is properly grounded. Do not modify the
plug provided with the product. If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
Storage and Maintenance Instructions
1. Store the product between 32°F-104°F (0 °C -40 °C ). Avoid exposing the product to rain or using the product in
a humid environment.
2. To preserve the battery lifespan, charge to 100% after using. If you plan to store your power station, recharge
to 100% every 3 months.
3. Keep the product on a flat surface when using, charging, and storing.
Bluetooth: The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and
any use of such marks by Anker Innovations Limited (or Anker Technology Co., Limited) is under license.Other
trademarks and trade names are those of their respective owners.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1780 is in compliance with Directives
2014/53/EU & 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet
address: https://www.anker.com
Maximum output power: +4dBm (For EU)
Frequency band: 2.4G band (2.4000GHz - 2.4835GHz)
Directive 2014/53/EU radiation exposure statement
This equipment should be installed and operated with minimum distance 20cm between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A1780 is in compliance with Radio Equipment
Regulations 2017 & The Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012. The full text of the GB declaration of conformity is available at the following
internet address: https://www.anker.com.
Anker Innovations Limited | Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, HongKong
The following importer is the responsible party (contract for EU and UK matters)
Anker Innovations Deutschland GmbH | Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Limited,
GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom
EN 08