General Warnings; Protect On Of The Env Ronment; Installat On - Candy CH64EXCP Gebrauchs- Und Installationsanweisungen

Identification Plate (located under the hob's bottom casing)

1. GENERAL WARNINGS

By plac ng the mark on th s appl ance we are assur ng
compl ance to all European Safety, Health and Env ronment
requ rements wh ch are appl cable for th s product category.
2. PROTECTION OF THE ENVIRONMENT
This appliance is marked according to European
Directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
WEEE contains both polluting substances (which
can cause negative consequences for the
environment) and basic components which can be
reused.It is important to have WEEE subjected to
specific treatments, in order to remove and dispose
properly all pollutants and recover and recycle all
materials.
Individuals can play an important role in ensuring that the WEEE
does not become an environmental issue; it is essential to follow
some basic rules:
• WEEE shall not be threatened as household waste.
• WEEE shall be handled over to the relevant collection points
managed by the municipality or by registered companies. In many
Countries, for large WEEE, home collection could be present.
• In many Countries, when you buy a new appliance, the old one
may be returned to the retailer who has to collect it free of charge on
a one-to-one basis, as long as the appliance is of equivalent
typology and has the same functions as the supplied one.
3. INSTALLATION
Install ng a domest c appl ance t s a compl cated operat on wh ch, f
not carr ed out correctly, can ser ously have mpact on safety of goods,
propert es or people. For th s reason, t should be carr ed out by a
profess onally qual f ed person n accordance w th techn cal
regulat ons.
In the event that th s adv ce t s gnored and nstallat on s carr ed out
by an unqual f ed person, the Manufacturer decl nes all respons b l ty
for any techn cal fa lure of the appl ance whether or not t results n
damage of goods or propert es or n njury of people or an mals.
After hav ng removed the packag ng please be sure that the appl ance
t s not damaged, otherw se contact the Reta ler or Manufacturer After
Sales Serv ce.
Make sure that the furn ture n wh ch the appl ance w ll be f tted and all
other furn ture n the nearby are made w th mater
ls wh ch can w thstand h gh temperatures (m n 100 °C).
In add t on, all decorat ve lam nates should be f xed w th h gh-res stance
glue.
Appl ance can be nstalled n a Bu lt- n furn ture n "Standard" or "Flush"
mode.
Worktop th ckness should be between 25 and 45 mm.
560 + 2
- 0
M n. 70 mm
490 + 2 mm
- 0
Standard nstallat on
per meter
PRODUCT CODE T
mm
523 + 2
- 0
Flush nstallat on
per meter
Note: Inner per meter d mens ons are same w th standard nstallat on
Leave a d stance of at least 55
mm between the hob and the
back wall and of at least 150
mm between the hob and the
vert cal furn ture or walls n the
lateral s de. If a furn ture s
nstalled above the hob, the
m n mum d stance requ red s
700 mm.
When nstall ng a hood above
the hob, please consult the
n s t a l l a t o n r e q u r e m e n t s
spec f ed for the hood but, n
any case, the d stance between
the hob and the hood must not
be lower than 700 mm.
If the bottom part of the hob is adjacent to an area normally accessible
for handling or cleaning operations, a separator it must be put 20 mm
below the bottom part of the hob.
When nstall ng an oven under the hob, separator must not be put and
the m n mum d stance between the bottom part of the hob and the
oven must not be lower than 10 mm. Do not nstall not cooled oven
under th s hob and nstall the oven follow ng ts own nstallat on
requ rements.
10 mm
min
05 GB
Slot depth: 5 mm
mm
150 mm
700 mm
55 mm