Bestway LAY-Z-SPA Mauritius AirJet Gebrauchsanweisung Seite 9

spa if the ambient temperature is below 15°C (59°F). We
suggest inflating the spa indoors, and then continuing to
setup outdoors. If the outdoor temperature is lower than 6°C
(42.8°F), the spa heater must always be on. In this mode,
the Freeze Shield™ system can keep the internal
temperature between 6°C (42.8°F) and10°C (50°F) to
prevent damage, such as water freezing in the pipes or the
circulation system.
CAUTION: If alarms pop up on the spa, the Freeze Shield™
system will stop working. Be sure to check the status of your
spa if the outdoor temperature is below 6°C (42.8°F). In case
of a long-term absence from home when there is a risk
of temperatures falling below 6°C (42.8°F), we strongly
suggest disassembling the spa and storing it following the
storage procedure.
• When the appliance will be not used for a long time, such
as in the winter, the spa or pool set should be disassembled
and stored indoors.
• Do not to place the spa on a slippery surface and make
sure the surface is free of sharp objects before installation.
• To avoid damage to the pump, the spa must never be
operated unless the spa is filled with water.
• For safety reasons, only use the accessories provided or
approved by the spa manufacturer.
• Regarding the information pertaining to the installation, refer
to the following paragraph of the manual.
• Whenever the spa is emptied, the filter should be cleaned
(and drained/dried, where applicable).
• Please examine equipment before use. Notify Bestway at
the customer service address listed on this manual for any
damaged or missing parts at the time of purchase. Verify
that the equipment components represent the models that
you had intended to purchase.
• This product is not intended for commercial use.
• Always keep the spa cover on to minimize heat loss during
heating of the spa between uses (but not while it is being
9