Husqvarna K 770 Dry Cut Bedienungsanweisung Seite 56

8. Push the choke control when the engine starts. If the
choke is pulled out, the engine will stop after some
seconds. If the engine stops, pull the starter rope
handle again.
9. Push the throttle trigger to disengage the start
throttle and set the product at idle speed.
To start the product with a warm engine
WARNING:
blade can rotate freely. It starts to rotate
when the engine starts.
1. Make sure that the STOP switch is in the left
position.
56
Make sure that the cutting
2. Pull the choke control fully and get the start throttle
position.
3. Push the decompression valve to decrease the
pressure in the cylinder. The decompression valve
goes back to its initial position when the product
starts.
4. Push the choke control to disable the choke. The
start throttle stays in position.
5. Hold the front handle with your left hand.
861 - 005 - 22.04.2022