Suntec Wellness KLIMATRONIC Heat Tower PTC Design 2000 OS Bedienungsanleitung Seite 11

• Do not place the heater directly under a power
socket, near curtains, drapes or other flammable
materials as well as walls and other objects.
• Never immerse the appliance, it's cord and plug into
water or other liquids.
Warning: In order to avoid overheating, do
not cover the heater!
Positioning of the appliance
The heater should only be operated at minimum distance of 50cm from any wall or other object. Position the air
flow in order to optimize the heating of the room. Avoid corners, small volumes, floors and ceilings.
Operation (1)
Operating voltage: 220-240V ~, 50Hz, 2000W
1. Carefully remove the heater from the plastic bag and the carton.
2. Place the heater on a firm leveled surface.
3. Set the main switch to the "Off" position and plug the mains plug of the power cable into the socket (220-
240V). Now set the main switch to "On".
4. If the device is in standby mode, all keys except the On / Off key are locked. Please press "ON / OFF" once
to operate the unit. Press "ON / OFF" again to turn off the unit. Once the unit is in operation, you can make
the following selections:
a) Low power: 1200W (confirm with the mode button)
b) High power: 2000W (confirm with the mode button)
c) Timer: from 1 to 8 hours (confirm with the timer button)
With the timer function you can set the duration of operation from 1 hour to 8 hours. Each time you press the
timer button, you increase the duration of operation by 1 hour. When the time setting is entered, the timer
counts down the hours in half and full hours and displays the remaining operating time until the unit stops
operating. Please press the timer button again after the display shows 8 hours to reset the unit to continuous
operation.
d) Oscillation: The heater can oscillate from left to right by pressing the SWING button.
e) All functions are shown on the LED display (2).
Warning
Before unplugging the unit from the wall outlet, turn it off and allow it to cool for 30 to 60 seconds to protect
internal components.
Remote control (3)
1. Please install a button cell battery CR2025 (not included)
2. All functions of the manual control via the unit's display are identical to the functions on the remote
control.
UP/DOWN: Adjust the temperature from 10-49°C.
CANCEL: You can cancel the temperature setting.