Flight Operation - Carson EASY TYRANN 550 2.4 GHz Betriebsanleitung

FLIGHT OPERATION

Trimming the quadcopter
Already shortly before the quadcopter takes off, you can recognize whether it wants to turn or
glide in a particular direction. Correct the deviations from the vertical ascent with the trim knob
of the turn function.
Tip of the fuselage turns to the right:
• Reduce speed and push the trim slider of the turn function on the left remote control lever
stepwise to the left.
• Push the pitch-lever forward again and check whether the correction was sufficient, if
necessary shift the trim further to the left.
• Repeat the process until the quadcopter no longer shows a tendency to turn to the right.
• Tip of the fuselage turns to the left:
TROUBLESHOOTING
Problem
The model does not move
Motor does not turn
The model reacts incorrectly to the control commands
or flies choppily
The model does not take off
The model moves forward/ backward and sidewise, but
does not hover
The model vibrates severely
Transmitter and Helicopter can not be binded
Can not take off
Blade A
GB // 18
• Proceed as described above, but push the trim slider of the turn
function stepwise to the right.
Cause
Check, if the transmitter and the model are switched ON.
Check the battery voltage of transmitter and model
Motor is defective
Motor is too hot
Check the state of the transmitter and receiver battery charges
Rotor blades are twisted
Motor is too hot
Batteries are empty
Check whether the Helicopter is exposed to a draught, e.g. by
an opened window or an air conditioner. Hover flight is not
possible when there is a draught
Check whether the rotors run true
Throttle control not set to minimum
Wrong installation on rotors
Reparation
Switch on the Transmitter and the Model.
Employ completely charged batteries
Exchange the motor
Allow the motor to cool down
Employ completely charged batteries
Exchange the rotor blades
Allow the motor to cool down
Charge the batteries or exchange them
Close the window/door, switch off the air conditioner or select
a more suitable room
Possibly change the rotor blades
Throttle need to be minimized to zero
Mount the propeller as shown below
Blade B