Machine Assembly - GGP ITALY B 28 Gebrauchsanweisung

106
EN
4. MACHINE ASSEMBLY
IMPORTANT
The machine is supplied with
some of the components disassembled and the
fuel tank empty.
WARNING!
Always wear strong work
gloves to handle the cutting devices. Mount
the components very carefully so as not to
impair the safety and efficiency of the ma­
chine. If in doubt, contact your dealer.
1. COMPLETING THE MACHINE
1a. "MONO" models (Fig. 1)
– P osition the upper part (2) with the front grip's
guard on the drive tube (1).
– F asten the lower cap (4) inserting the pin (4a) in
one of the three holes on the drive tube.
– Fully tighten the screws (4).
1b. "DUPLEX" models (Fig. 2)
– L oosen the screws (5) and remove the cap (4)
from the support (2).
– P ut the handlebar (1) into the seating in the sup-
port (2), located on the drive tube (3), making
sure that the controls are on the right.
– F it the cap (4), fully tightening the screws (5).
– F asten the casing (6) of the controls to its cable
fastener (7).
2. M OUNTING THE ROD
(Models with separate rod – Fig. 3)
– P ull out the stop pin (5) and push the lower part
of the rod (4) right down until the stop pin (5)
slots into the hole (6) in the rod. This is easier to
do if you rotate the bottom of the rod (4) slightly
in both directions. The pin (5) is in place when it
is completely lodged in the hole.
– Lastly, tighten the knob (7) securely.
3. FITTING THE GUARDS
WARNING!
Each cutting device is pro­
vided with a specific guard. Never use guards
other than those indicated for each cutting
device.
All manuals and user guides at all-guides.com
• 3 or 4 point blade (Fig. 4)
and fit the blade guard.
– R emove the blade (if fitted) as described in
– T he guard (1) is fixed to the angle transmission
• Cutting line head (Fig. 5)
line head the additional guard, with line cut­
ting knife, must always be fitted.
– R emove the blade (if fitted) as described in
– T he guard (1) is fixed to the angle transmission
– A ssemble the additional guard (4) fastening it
4. R EMOVING AND REFITTING
devices or ones homologated by the Ma nu­
facturer.
• 3 or 4 point blade (Fig. 6)
and fit the blade guard.
left­hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlockwise.
– I nsert the wrench supplied (2) into the specific
– R emove the split pin (4) and unscrew the nut (5)
– P ull out the washer (6) and the outer ring-nut (7)
MACHINE ASSEMBLY
WARNING!
Wear protective gloves
paragraph 4.
(2) by four screws (3).
WARNING!
When using the cutting
paragraph 4.
(2) by four screws (3).
into place on the guard (1).
THE CUTTING DEVICES
WARNING!
Use only original cutting
WARNING!
Wear protective gloves
NOTE
The fastening nut (5) has a
hole in the angle transmission (3) and rotate the
blade (1) by hand until the wrench enters the
inner hole, blocking rotation.
in a clockwise direction.
and remove the blade (1).