Overheat Protection - Kalorik KA EL 17-7 Gebrauchsanleitung

Fax +32 2 359 95 50

3. After 10-15 minutes, if you feel the room temperature is too low or too high, just adjust the
temperature to the desired position.
4. If you want to switch off your appliance, turn off the two power switches at the same time
(the indicator light will be off), remove the plug from the power supply and place it in its
storage location. CAUTION: YOUR APPLIANCE WILL REMAIN HOT FOR A FEW MINUTES.
5. To move your appliance, take it by its handle, raise it and roll it.

OVERHEAT PROTECTION

This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat. In this case, unplug the appliance, wait about 10 minutes
for it to cool. Then switch it back on as described above. The appliance should operate
normally. Should the problem persist, please contact the nearest customer service.
GENERAL CLEANING AND CARE
 Before cleaning the appliance, ensure it is disconnected from the power supply and has
cooled down completely.
 Do not clean the radiator with water and do not immerse it.

The housing may be wiped with a slightly damp, lint-fee cloth.
PROTECTION OF THE ENVIRONMENT– DIRECTIVE 2002/96/EC
In order to preserve our environment and protect human health, the waste electrical and
electronic equipment should be disposed of in accordance with specific rules with the
implication of both suppliers and users. For this reason, as indicated by the symbol
rating label or on the packaging, your appliance should not be disposed of as unsorted
municipal waste. The user has the right to bring it to a municipal collection point performing
waste recovery by means of reuse, recycling or use for other applications in accordance with
the directive.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must reproduced and folded in order to obtain a mini
booklet A5 (+/- 150 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don't change the page numbering. Keep the language
integrity.
9
Assembly page 9/24
on the
KA EL 17-7/9/11 - 060626