Installation; Fixture Assembly & Installation; Recommended Coverage - Lumatek LUMLED013 Bedienungsanleitung

6. INSTALLATION

Warning! Mounting and installing the LED fixture must be in accordance with the applicable local laws and
regulations.
Warning! The installer is responsible for correct and safe installation.
Warning! Ensure the local cabling can support the voltage and current requirements of the LED fixture.
Warning! Avoid coiled cables and keep mains leads separated to help prevent electromagnetic interference.
Warning! Do not connect or disconnect the LED fixture under load.
6.1 Fixture assembly & installation
WARNING! The light bar is shipped with a protective plastic cover over the diodes. Please ensure this protective
cover is removed before use!

6.2 Recommended Coverage

The Lumatek 30W UV Supplemental LED Bar was designed to fit directly into the Zeus fixtures.
To make sure you achieve the best light spread over the canopy, we recommend:
Integrate a minimum of 2 units of 30W UV Supplemental Light LED Bar, with:
• ZEUS 465W 2.6 - 1.2 x 1.2 m footprint
• ZEUS 600W 2.6 - 1.4 x 1.4 m footprint
• ZEUS 465W PRO 2.9 - 1.2 x 1.2 m footprint
• ZEUS 600W PRO 2.9 - 1.4 x 1.4 m footprint
• ZEUS 1000W Xtreme CO2 - 1.5 x 1.5 m footprint w/ CO2 Supplement
Integrate a minimum 3 units of 30W UV Supplemental Light LED Bar, with:
•
ZEUS 1000W PRO - 2.0 x 1.5 m footprint
Insert the metal hanger hooks into the mounting
holes on each side of the light bar, at both ends.
The UV bar can be placed between the Zeus
fixture full spectrum bars and supported with the
metal hangers placed over the Zeus frame end
pieces.