Installation; Fixture Assembly & Installation; Connect The Led Light Bars - Lumatek ZEUS 600W 2.6 Handbuch

6. INSTALLATION

Warning! Mounting and installing the LED fixture must be in accordance with the applicable local laws and
regulations.
Warning! The installer is responsible for correct and safe installation.
Warning! Ensure the local cabling can support the voltage and current requirements of the LED fixture.
Warning! Avoid coiled cables and keep mains leads separated to help prevent electromagnetic interference.
Warning! Do not connect or disconnect the LED fixture under load.
6.1 Fixture assembly & installation
Connect Frame A and B to the support frame by pressing button on frame connector and inserting
into support frame socket and lock. Ensure button clicks into hole socket to lock.
Connect Frame B to support frame end near LED driver power output & dimming female connectors.
Note the direction when installing; the driver tray is on top when the fixture is hung.

6.2 Connect the LED Light Bars

Warning! The light bars are shipped with protective plastic covers over the diodes. Please ensure
these protective covers are removed before use!
Install hook end first; insert hook into square hole Then insert the other end; align the light bar's magnet
connector with the round hole on Frame connector
and insert male pin into female socket.
Ensure magnetic connection is secure.