Connect To Wifi Via Ap Mode; Wi-Fi Function On/Off; Technical Specifications - Sundirect LM600-Pro Bedienungsanleitung

6.4.3 Connect to WiFi via AP mode:

If the connection fails for any reason, please repeat the procedure and try again. Sometimes failures
are caused by network errors or packet losses using a Wi-Fi system.
6.4.4 Disconnect the Wi-Fi
If you would like to disconnect the Wi-Fi of your current heater, long press the "-" button on the
touchscreen for 5 seconds until the Wi-Fi indicator start to flash again. Now the heater is operating
manually without Wi-Fi.

6.4.5 Wi-Fi function on/off

Long press "-" button for 10 seconds you are able to turn off the Wifi function of this heater and the
wifi signal on the screen will disappear, long press "-" button again to turn it on.
7. Technical Specifications
Panels covered by these instructions are listed in the table below.
Model
LM600-Pro
Power Size
600W 65*110cm
Step1: Activate the Power switch,
long press the "-" button for 5
seconds until the Wi-Fi signal
indicator flashes slowly. Open the
APP on your smart phone and add
your device, choose the AP mode.
Step2: Enter the Wi-Fi password of
your 2.4GHz Wi-Fi channel network.
Please make sure your home Wi-Fi
is working as well as keep the
heater and smartphone as close as
possible to the Wi-Fi router.
Step3: Follow the instruction inside
the APP and connect your mobile
phone to the device's hotspot and
go back to the APP.
Step4: Wait till the connecting
status shows 100% to finish the
process.
Weight Mounting
15Kg Wall mounting
10
IP Protection
IP44