INSTALLATION MANUAL
Sundirect Infrared Heaters
Sundirect Technology Ltd.
info@sundirect-heater.com
www.sundirect-heater.com
Ceiling installation manual for PE series using BC002
Note: The kit supplied in the package is designed for mounting on a solid
ceiling. If mounted onto other types of ceilings, you will need appropriate
fixings (not supplied). Please make sure the ceiling is safe to mount. We
highly recommend to have the panel installed by a qualified electrician or
installer authorized by Sundirect.
Sundirect and the Sundirect Logo are registered Trademarks of Sundirect Technology Ltd.
© Sundirect Technology Ltd. All rights reserved.
Step1: Drill four 2mm diameter holes on the
brackets of the backside of the panel as
shown in the drawing.
Step2: Close Part A by using the screw (Part
F) with a screw driver, please make sure Part
A is closely attached to the bracket.
Step3: Insert the cable (Part H) into Part B
and tighten them with Part A.
Step4: Drill four 8mm diameter holes into
the ceiling.
Step5: Insert the anchor (Part G) into the
holes on the ceiling, and fix Part D to the
ceiling by using the screw (Part E).
Step6: Insert the cable (Part H) into Part C,
then attach and close it to Part D. Make sure
that the remaining part of the cable sticks
out of the hole on the side of Part D.
Step7: Adjust the cable (Part H) to the
desired length, you can always adjust the
length of the cable by pressing the end of
Part C.