SuperFish TopClear Pro 36000 Gebrauchsanweisung Seite 7

UVC timer switch
The UVC timer switch (k) [24 hours/12 hours/0 hours] allows you to choose
between constant operation of the UVC in summer, 12 hours of operation (per
day) in spring and autumn, and you can switch off the UVC. This saves energy at
times when the UVC is not needed and extends the service life of the UV lamp.
The 12-hour on/12-hour off interval starts when you select this mode
Filter cleaning system with backwash function
You should clean the filter foam regularly, as dirt accumulates in the filter foam.
When first installed, or if your pond is heavily soiled, it may be necessary to clean
the filter foam daily. To do this, activate the automatic filter cleaning system, the
filter foam pack rotates and is wrung out, the waste water drains away via the
drain. There is no need to open the filter for this and an audible signal sounds
when cleaning is complete.
• Clean the filter foam as soon as the dirt indicator (l) shows, or clean it
once a week.
• Make sure a pond hose is connected to the waste water drain so the water can drain into the sewer or use it for
watering the garden.
• Set the blue lever (j) to CLEAN, after which the UVC will switch itself off, the filter foam pack will rotate and the
water will be diverted via the waste water drain.
• As soon as the audible signal sounds or the rinse water is clear again, move the blue lever back to FILTER. The filter
foam pack stops rotating, the UVC switches back on and the filter operates normally again.
• Check that the water flows into the pond through the outlet and the flow rate is sufficient.
Maintenance of the filter
If the flow rate remains insufficient after automatically cleaning the filter foam, you should clean or replace the filter
foam manually. To do this, dismantle the filter foam pack (d).
• First, unplug the filter and the pump.
• Remove the outer clamp (b) and carefully remove the cover (c) with the UVC from the filter housing (a).
• Remove the filter foam pack from the filter housing.
Fig. D Scan the QR code for the instruction video explaining how to disassemble the filter foam
pack.
• Rinse the filter foam clean in a bucket of pond water and wring it out well.
• NEVER use detergents to clean the filter, this will harm your fish, plants and the beneficial
bacteria in your filter.
• Replace the filter foam pack (Art. 06030125) once a year. The filter foam pack consists of 4 yellow (fine) and 3 blue
(coarse) layers of filter foam.
Fig. E Clean the Bio-Balls once or twice a year by rinsing them with pond water. Do not use tap water for this purpose.
The trays (f) containing the Bio-Balls can be easily opened by turning turning the black slatted cover anticlockwise
and lifting it off. In the same way, you can also take off the upper tray.
• Place the whole assembly back into the filter housing in the correct order, check that the O-ring (e) is in the correct
position in the rim of the filter housing. Replace the cover with the UVC in the correct position and close the outer
clamp.
• Turn the pump and filter back on by plugging in the plugs.
7