Connective Pipe And Drainage Installation - Zibro SC 3125 kids Gebrauchsanweisung

2. Always use wall hole conduit when drilling metal grid, metal plate or the like.

3. Connective pipe and drainage installation

Always run the drain hose sloping downward all the way. Do not install the drain hose as
illustrated below.
Fig. 6
Do not block water flow by a rise.
1. When connecting extension drain hose, insulate the connecting part of extension drain hose with a
shield pipe, do not let the drain hose slack.
Fig. 7
Connective pipe
2. For the left-hand and right-hand piping, remove the pipe cover from the side panel. The pipe cover
must be kept as it may be used when relocate the air conditioner to any other place.
Pipe holder
Pipe Cover (right)
Right piping
Fig. 8
ATTENTION
Always use the highest care when bending the piping. Make sure that the piping always is
bended and not nodded. In case of a nodded pipe: do not attempt to install this nodded pipe as
this is a potential refrigerant leak.
4. Indoor unit installation
1. Pass the piping through the hole in the wall.
2. Put the upper claw at the back of the indoor unit on the upper hook of the installation plate, move the
Do not put the end of drain hose
into water.
Upper Hook
Lower Hook
Cushion
material
Pipe Cover (left)
Left piping
Left back piping
Right back piping
4
73