96922 en Milchaufschaeumer_v9_Layout 1 13.07.21 06:52 Seite 17
base. When the base is switched on, metal objects that
come into direct contact with the induction surface are
heated.
Place the appliance on a firm, level, easy-to-clean
•
surface that is easily accessible.
The appliance must not slip around or overturn.
Route the mains cable so that no one can trip over it.
Do not let the mains cable dangle off the table, as it
may get caught on something and accidentally pull
the appliance down.
CAUTION – material damage
Pay attention to the MIN and MAX markings inside the
•
milk jug. The connecting piece in the bottom of the milk
jug must be covered with milk.
If there is not enough milk in the milk frother, the
appliance can overheat. The milk can froth over if it
is overfilled.
The warming and frothing process must have completed
•
and the milk frother must be switched off before you
remove the milk jug from the base.
Position the milk frother at a sufficient distance from
•
sources of heat such as ovens or hotplates.
Do not use any caustic, aggressive or abrasive products
•
for cleaning.
Only use original accessories.
•
It cannot be fully ruled out that some varnishes,
•
synthetic substances or furniture polishes may react
adversely to the non-slip material of the feet and
soften them. To avoid unwanted marks on furniture,
place a non-slip mat underneath the base if necessary.
17
17