Klarstein HEAT'N BEAT 10035262 Bedienungsanleitung Seite 19

Operation by the Control Panel
Press this switch, the unit power-on. When the O/I switch is turned off, all
O/I
other functions are also stopped.
Press this button to turn ON the fireplace. Press again to turn off the
fireplace and the fan will continue to work for 60 seconds without heat.
Press this button to change the flame colour. If you press the button once,
the flames light up yellow. Press twice for yellow and blue flames. Press
three times for blue flames.
Press this button to change flame effect. Press again to decrease the flame
intensity. There are 6 light intensities for your selection. The flame optics will
go lower under the sequence of 6 – 5 – 4 – 3 – 2 – 1. Pressing the button
again will stop the flame effect.
Press this button to the desired temperature. When desired ambient
temperature is reached, the heater will automatically stop heating. When
the ambient temperature drops below the desired temperature 2 °C, the
heater will resume heating.
Operation by the Remote Control
Press this button to turn ON the fireplace. Press again to turn off the
fireplace and the fan will continue to work for 60 seconds without heat.
Press this button to toggle between the two temperature scales Celsius
(°C) or Fahrenheit (°F). The current setting is displayed on the LED screen.
Press this button for timer function. "0H" to "8H" is displayed on the
LED screen. "0H" means there is no set running time and heater will run
continuously. The displays "1H" to "8H" indicate the number of hours the
heater will operate before shutting off.
Press this button to change flame effect. Press again to decrease the flame
intensity. There are 6 light intensities for your selection. The flame optics will
go lower under the sequence of 6 – 5 – 4 – 3 – 2 – 1. Pressing the button
again will stop the flame effect. By default the flame colour is yellow.
Hold it for about 3 seconds to change flame colour. The flame colour will
change under the sequence of yellow – yellow and blue – blue.
Press up or down button to the desired temperature. When desired
ambient temperature is reached, the heater will automatically stop heating.
When the ambient temperature drops below the desired temperature
2 °C, the heater will resume heating
EN
19