Manual Installation (Wlan) - Block CVR-200 Bedienungsanleitung

Manual WLAN installation
If any problem appears while setting up the assistant wizard, or you prefer to do a manual setup, please pro-
ceed as follows:
▶ Press the „Menu" button on the remote control. Using the arrows keys on the remote control, choose first
„System Settings", then select „Internet Settings", then „Manual Settings", then „Wireless".
▶ Select in the next step „DHCP active". This is the default setting of all conventional Internet router and it
takes a lengthy network configuration * Confirm the setting.
▶ Now enter the name of your wireless network (SSID), pay attention to the correct spelling and use of capi-
tal/small letters. Confirm with "OK".
▶ Select the type of your password protection (usually WPA2 and AES). In case of doubt, consult the manual
of your router.
▶ Enter the password of your WLAN network, pay attention to the correct spelling and use of capital/small
letters. Confirm with "OK".
▶ Now the router and your CVR-200 should be connected and an Internet connection should exist, „Connec-
ted" shall appear on the display.
* Should you have disconnected the DHPC function on you router, select please "DHPC inactive". In this case, you must configure the Network, the rules
and specification should be known by now. For the configuration, you may need the MAC address of your Block device. You can find this under Menu/
System settings/Internet settings/Adjustment indicator/MAC address.
44