Cleaning And Maintenance - HQ Power VDPL300QF2 Bedienungsanleitung

To set the device to work with a DMX controller:
1 . On the back panel [ 5 ] , set DIP switches 9 and 10 to OFF.
2 . Use DIP switches 1 – 8 to specify the DMX address:
a ddr e ss D I P sw it ch e s
5
19
40
D M X cha nne l va lue s
Ch a n n e l Fr om
0
7
1 67
130
193
0
7
2 67
130
193
0
7
3 67
130
193
0
4
7
0
5
31
0
6
31
0
7
31
N ot e s
•
CH1 to CH4 can work together with CH5; the values of CH5 must be set between 0 and 30.
•
When using CH 6, the values of CH5 must be set between 31 and 255.
•
You can use CH1 to CH6 together with CH7 for strobe effects.
•
Channel 7 (strobe) only works if other channels (CH 1 to CH 6) are active.
8 . Cle a ning a nd m a int e na nce
•
All screws should be tightened and free of corrosion.
•
The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension,
trussing) should not be deformed, modified or tampered with; e.g. do not drill extra holes in mounting
supports, do not change the location of the connections...
•
Moving mechanic parts must not show any signs of wear and tear.
V. 03 – 22/06/2012
All manuals and user guides at all-guides.com
VD PL3 0 0 QF2
To Fu n ct ion
6 Off
66 Group 1 red lights on
129 Group 2 red lights on
192 Group 3 red lights on
255 All red lights on
6 Off
66 Group 1 green lights on
129 Group 2 green lights on
192 Group 3 green lights on
255 All green lights on
6 Off
66 Group 1 blue lights on
129 Group 2 blue lights on
192 Group 3 blue lights on
255 All blue lights on
6 Off
255 All white lights on
30 Off
255 Built-in program (speed increases according to channel settings)
30 Automatic
255 Built-in program
30 Strobe effect off
255 Strobe effect (speed increases according to channel settings)
sw it ch r e pr e se n t s
1 1
2 2
3 4
4 8
5 16
6 32
7 64
8 128
6 ©Velleman nv