Removal And Disposal - HEIDENHAIN EIB 700 Betriebsanleitung

7

Removal and disposal

7.1 Overview
This chapter contains information and environmental
protection specifications that must be observed for
correct disassembly and disposal of the product.
The following steps must be performed only
by qualified personnel.
Further information:
Page 23
NOTICE
Depending on the connected peripherals, special safety
precautions may be required.
Comply with the corresponding safety precautions,
which are given when installing the relevant
components, see "Installation", Page 26
7.2 Removal
Storage after removal
If the product will be temporarily stored after removal, the
specified ambient conditions must be maintained.
"Specifications", Page 33
Further information:
Packing the product for storage
Repackaging should correspond to the original packaging
as closely as possible:
Re-attach all connection parts to the product as they
were attached when received from the factory, or
repackage them in the original packaging as received
from the factory.
Repackage the product, foam and cardboard box insert
as originally shipped from the factory
Place all other components in the original packaging as
received from the factory.
supplied", Page 24
Enclose all the documentation that were included in
the original packaging.
Further information:
and distribution of the documentation", Page 21
When returning the device to the Service
Department, accessories and measuring
devices need not
32
"Personnel qualification",
Further information: "Items
"Storage
be returned with the device.
7.3 Disposal
Incorrect disposal of the product!
Incorrect disposal of the product can cause
environmental damage.
Do not dispose of electrical waste and
electronic components in domestic
waste
Forward the product to recycling in
accordance with the applicable local
disposal regulations
If you have any questions about the disposal of the
product, please contact a HEIDENHAIN service
agency
NOTICE
HEIDENHAIN | EIB 700 | 07/2018