Start-Up Procedure; Light Intensity Setting - SCHOTT KL 2500 LED Bedienungsanleitung

You can switch the KL 2500 LED on and off by pressing the main switch. If the
device is switched on, the green control lamp and the LCD display light up.
To disconnect the power supply, pull out the plug!
Adjust the light intensity by turning the light intensity control. The light
intensity is shown in the LCD display in values from 0% to 100%.
You can adjust the light intensity in three sensitivity levels:
1. Standard: in 1% steps
2. Coarse: in 5% steps. "Coarse" is shown in the display.
3. Fine: in 0.1% steps. "Fine" is shown in the display.
Briefly press the light intensity control to switch between the sensitivity levels.
Attention: The device is not switched off in the 0.0% control position, therefore
the green control lamp lights up. To switch off the KL 2500 LED, press the main
switch.
The percentage display in the LCD display corresponds to the respective current
consumption of the LEDs. The control is linear. However, the radiant power of
the LEDs is not proportional to the current consumption. The intensity change
in the control range at more than 50.0% is therefore lower than in the lower
control range.
Press the light intensity control for more than two seconds to manually save the
displayed brightness. "Saved" then appears in the LCD display. If a light intensity
has been saved, the KL 2500 LED light source lights up with this saved light
intensity in the "Standard (1%)" sensitivity level after it has been switched off
and on again.

2.3 Start-up procedure

2.4 Light intensity setting

17
EN