Operating - VONROC EH515AC Bersetzung Der Originalbetriebsanleitung

EN
8. Indicators
A. Eco mode indicator
B. High heating indicator
C. Low heating indicator
D. Celsius indicator
E. Fan indicator
F. Lock indicator
9. Temperature button
10. Heater and control panel on/off button
11. Mode button
12. Oscillation button
13. Timer / lock button
14. Remote control
15. Heater on/off button
16. Light on/off button
17. Temperature increase button
18. Temperature decrease button
19. Timer button
20. Remote control storage
21. Air inlet

3. OPERATING

Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of stainless steel and was coated
with protection oil by production. The smoke is
caused by the left oil when heated.
Placing the electric heater
• Place the heater upright on a firm and a level
surface.
• Keep a minimum distance of 1 m between the
front of the housing and walls and 30 cm from
all other housing surface areas. Keep away from
wet environments.
Warning! Make sure to place the heater in a
safe spot, so you cannot easily trip over the
machine and cable. Make sure to place the
heater where it cannot fall down / of.
Starting the electric heater (Fig. A, B, C)
• Plug in the cable to the mains power outlet. The
heater and control panel on/off button (10) will
light up.
6
• Press the heater and control panel on/off but-
ton (10) to start the heater. The default heating
mode is high heat, the high heat indicator (8B)
will light up. Press the mode button (11) to
change the heating mode.
- Eco mode: the eco mode indicator (8A) will
light up. The indicator light (3) will flash red
slowly.
- Fan: The fan indicator (8E) will light up. The
indicator light (3) will turn blue.
- Low heating mode – 1200W: the low heating
indicator (8C) will light up. The indicator light
(3) will turn purple.
- High heating mode – 2000W: the high heating
indicator (8B) will light up. The indicator light
(3) will turn red.
Adjusting the temperature (Fig. B, C)
• By default, the ambient temperature is shown
on the display.
• By default, the temperature is 30
rature can be set between 15
• Set the temperature as desired by press the
temperature button (9, 17, 18). The target tem-
perature will flash.
• The target temperature will keep flashing for
3 seconds after the last button press, then the
display will show the ambient temperature.
Constant room temperature
The heater starts and stops automatically to keep
the room temperature constant. Once the ambient
temperature in the room reaches the desired target
temperature, the heating element will be in standby
mode. Once the ambient temperature starts to
decrease, the heating element will be switched on
again.
Functions of the control panel (Fig. B)
The heater can be operate by the control panel. The
available functions are:
- Temperature button (9): Press to increase
the desired ambient temperature. When the
maximium of 35 C is reached, it will start again
o
at 15 C.
o
- Heater and control panel on/off button (10):
Turns the heater on and off. Hold the button
for 3 seconds to turn the control panel off. To
activate hold again for 3 seconds.
- Mode button (11): Cycles between eco mode,
low and high heating.
C. The tempe-
o
C and 35 C.
o o
WWW.VONROC.COM