Operating - VONROC EH514AC Bersetzung Der Originalbetriebsanleitung

3. OPERATING

Check the device for damage before use
and only use in good working condition.
When using the heater for the first time, you may
notice a slight emission of smoke. This is quite
normal and it stops after a short time. The heating
element is made of stainless steel and was coated
with protection oil by production. The smoke is
caused by the left oil when heated.
Placing the electric heater
• Place the heater upright on a firm and a level
surface.
• Keep a minimum distance of 1 m between the
front of the housing and walls and 30 cm from
all other housing surface areas. Keep away from
wet environments.
Warning! Make sure to place the heater in
a safe spot, so you cannot easily trip over
the machine and cable. Make sure to place
the heater where it cannot fall down / of.
Starting the electric heater (Fig. A, B)
• Plug in the cable to the mains.
• Press on/off button (8) on.
• The indicator light (3) will light up blue and just
the fan will turn on.
• Press the mode button (7) to change heating or
cooling.
- Low heating mode – 600W: the indicator light
(3) will turn yellow.
- High heating mode – 1200W: the indicator
light (3) will turn red.
- Fan: the indicator light (3) will turn blue.
Adjusting the temperature (Fig. B)
• By default, the ambient temperature is shown
on the display (5).
• By default, the temperature is 25
perature can be set between 15
• Set the temperature as desired by press the
temperature button (6).
• The target temperature will keep flashing for
5 seconds after the last button press, then the
display will show the ambient temperature.
WWW.VONROC.COM
Constant room temperature
The heater starts and stops automatically to keep
the room temperature constant. Once the ambient
temperature in the room reaches the desired target
temperature, the heating element will be in standby
mode. Once the ambient temperature starts to
decrease, the heating element will be switched on
again.
Timer button (10)
The timer can be set between 1 hour and 9 hours.
Press the timer button (10) to set the timer with
1 hour intervals. The set timer will keep flashing
for 5 seconds after the last button press, then the
display will show the ambient temperature. Without
a timer there is no limit.
Oscillation button (9)
Press the oscillation button to activate the heater
to swing. Press it again to deactivate.
Tip-over switch (11)
This heater has an mechanical tip-over protection.
This protection ensures when the heater is not
placed upright on a firm and level surface or when
the heater tip over, the system will automatically
shut the heater off. If this occurs, put the heater on
a firm and level surface and start the heater again.
Automatic Overheat Safety Control
This heater is equipped with safety internal heat
limiting thermostat and overheat protection circuit.
When a potential overheat temperature is reached,
the system will automatically shut the heater off.
If this occurs, the heater can only resume after
resetting it. To reset the heater: Unplug the heater
and wait at least 30 minutes to cool down before
restarting the heater.
Stopping the electric heater (Fig A,B)
C. The tem-
o
C and 35 C.
o o
• Press the on/off button (8).
• The indicator light flashes blue and the fan will
cool down the heater for a few minutes. The
temperature LED-display (5) shows "OF".
• Pull the plug out of the mains power outlet.
Let the machine cool down before turning
off by using the ventilation function.
EN
5