Sharp AH-AP18DR Bedienungsanleitung Seite 15

TIMER ON
The unit will turn on automatically according to your setting.
Timer duration can be set from minimum 0.5 hours (30 minutes) to maximum 12
hours.
Up to 9.5 hours, you can set by 0.5 hours (30 minutes) increments and from 10 to 12
hours, by 1 hour increment.
MODE TEMP.
FAN TIMER
TEMP.
DISPLAY MODE
1h FAN
SWING CANCEL
Example : When you wish the
room temperature
to be as desired
6.5 hours later.
NOTES FOR TIMER SETTING AND OPERATION
• The latest time setting will be memorized and will appear on the remote control display the next
time you set the TIMER OFF or TIMER ON.
• TIMER OFF and TIMER ON can not be set together.
The latest set TIMER will be active.
• When ONE-HOUR OFF TIMER is set, TIMER OFF and TIMER ON will not be available.
• When ONE-HOUR OFF TIMER is set during TIMER OFF or TIMER ON duration, the TIMER ON
or TIMER OFF will be cancelled.
Point the remote control at the signal receiver win-
dow on the unit.
1
Press the TIMER ON (
• The time setting will change as you press the button
as follows.
0.5h
Hold the button pressed down for fast setting.
• The orange TIMER lamp (
1
• The unit will generate a beep when it receives the
signal.
• The time setting will count down to show remaining
time.
Select the mode, temperature, fan speed setting
and PLASMACLUSTER operation as desired.
• When the temperature is set with the TIMER ON,
the temperature will show in the display for 5 sec-
onds and then return to the time display.
• If you do not change the setting, the unit will oper-
ate with the latest setting.
• The unit will turn on prior to the set time to allow
the room to reach the desired temperature by the
programmed time. (Awaking function)
E-13
) button.
1.0h 1.5h 10h
) on the unit will light.
11h 12h