RUSTA SILENCE Gebrauchsanweisung Seite 9

CLEANING THE FILTER
To maintain optimum performance of your cleaner, please wash the filters after each
5 bag changes.
CLEANING THE PRE-MOTOR FILTER
1. Lift the bag door release latch to open the bag door and remove the bag holder. (Fig. 8)
2. Remove the pre-motor filter frame from the cleaner. (Fig. 12)
3. Remove the filter sponge from the holder. (Fig. 13)
4. Wash it in hand warm water, and allow it to dry thoroughly before replacing it in the
cleaner. (Fig. 17, 18)
CLEANING THE EXHAUST FILTER AND EXHAUST SPONGE
1. To remove the exhaust sponge and the exhaust filter, remove exhaust sponge 1
from the exhaust cover and unclip the filter pack and remove the other sponge 2.
(Fig. 14, 15, 16)
2. Wash them in hand warm water and allow them to dry thoroughly before replacing.
(Fig. 17, 18)
REMEMBER! Do not use hot water or detergents. In the unlikely event the filters
become damaged, new filters will need to be fitted. Do not try and use the product
without a dust bag or filter fitted.
CLEANING THE PERMANENT CLOTH DUST BAG
To maintain optimum performance, we recommended that you wash the permanent
cloth dust bag under warm water after every 5 full bags. Remove excess water and
leave to dry fully before replacing.
REMOVING A BLOCKAGE FROM THE SYSTEM
If the bag check indicator LED is illuminated or flashing:
1. Check if the bag is full. If so refer to "Replacing the dust bag".
2. If it is not full, then:
A. Do the filters need cleaning? If so refer to "Cleaning the filter".
B. Check if there is any other blockage in the system - Use a cord or a pole to
remove any blockage from the telescopic tube or flexible hose.
WARNING! The bag check indicator LED will turn on if the
cleaner is used when full, if there is a blockage or if the
filters are dirty. If the cleaner is used for a significant period
of time with the bag check indicator LED on, a thermal cut
out will switch the cleaner off to prevent overheating.
9