Mounting A Cut-Off Wheel; Dismounting A Cut-Off Wheel - struers Labotom-3 Handbuch

Mounting a Cut-off Wheel

Nut

Washer

Flange


Dismounting a Cut-off Wheel

Labotom-3
Instruction Manual
Put the rim into the groove in the top of the guard for the cut-off

wheel and slot the cut-off wheel into position.
Mount the flange, washer and nut.

Press the knob for the spindle lock on the right-hand side of the

cut-off wheel, turning the cut-off wheel until the spindle lock
clicks.
Tighten the nut moderately with the fork spanner and release the

spindle lock.
Note: The spindle on Labotom-3 is left-hand threaded.
Conventional cut-off wheels like Al
cardboard discs, to protect the cut-off wheel.
For maximum precision with diamond or CBN cut-off wheels, do not use
Push the cutting handle backwards to place the tilting cutting unit

in the back position.
Press the knob for the spindle lock on the right-hand side of the

cut-off wheel, turning the cut-off wheel until the spindle lock
clicks.
Remove the nut with the fork spanner. Remove the washer,

flange and old cut-off wheel.
Note: The spindle on Labotom-3 is left-hand threaded.
IMPORTANT
O /SiC should be placed between two
2 3
cardboard discs.
11