How To Work The Lcd Control Panel - SACH VAC3 Dynamic Bedienungsanweisung

VAC3 - Central Vacuum System

7.3.1 HOW TO WORK THE LCD CONTROL PANEL

1
4
For manual operation of the central vacuum unit, gradually depress the key indicated by the symbol "+"
on the control panel to increase the vacuum power. To stop vacuuming, press the key indicated by the
symbol "-" on the control panel, then depress the key marked "OFF" to stop vacuuming.
To view the di erent control menus of the LCD panel depress the MODE key. The central vacuum must
not be in use, otherwise it will not be possible to view the menus. If the system is operated from the hose
handle, it is not possible to stop it manually using the "OFF" key on the central vacuum's control panel.
1. Power indicator: This provides us with an indication of the level of power at which the motor
is working. This can be adjusted by depressing the keys with symbols "+" and "-" on the control
panel or sliding the switch up or down on the hose handle.
2. Hepa lter indicator: When the small black frame is completely shaded the protective lter and
the Hepa cartridge need cleaning. The Hepa lter warning indicator works for a pre-determined
period, say 50 hours. To reset this symbol you should press "
"OFF" during 5-10 seconds.
3. Electrical protection indicator: The indicator should ash if the thermostat or circuit breaker is
activated. In this event you should switch o the central vacuum unit and disconnect it from the
electrical supply. Wait until the thermostat cools down or depress the circuit breaker button and
start the central vacuum up. If the central vacuum doesn't start up, get in contact with SACH's
after-sale service team.
4. Indicator showing duration of operation: Depress the "MODEL" key and you will see the total
length of time the central vacuum unit has been working.
5. Bin full indicator: When the small black bin is fully shaded this means the bin needs emptying.
See section "Cleaning and Maintenance" for instructions on how this should be carried out.
6. Motor maintenance or replacement indicator: When the indicator starts to ash, maintenance
or replacement of the central vacuum motor is required depending on the nature of the pro-
blem. If this symbol lights up notify SACH's technical service team.
2 3
5 6
1. Power level
2. Filter cleaning indicator
3. Thermal and electrical protection.
4. Counter
5. Dust container full indicator
6. Contact your service agent
" until see this symbol, then press
24
User guide