General Instructions For Vac3 Dynamic - SACH VAC3 Dynamic Bedienungsanweisung

VAC3- Central Vacuum System

7.2 GENERAL INSTRUCTIONS FOR VAC3 DYNAMIC

1 2
7.3 GENERAL INSTRUCTIONS FOR AMTMOS DIGITAL
1. Connect the power cable (23) to the electrical supply. With the DYNAMIC
model there is nothing else you need to do. The central vacuum unit is ready
for use. The machine needs to be turned on by depressing the switch (1) only if
you require the central vacuum unit to work in manual mode. It is not necessary
in normal use as the central vacuum unit will start to work when the low-voltage
hose is inserted into an inlet valve.
2. To prepare the hose for use, connect the telescopic wand and the
appropriate tool for the type of oor surface you wish to clean, to the hose
handle.
3. Insert the hose cu into the inlet valve. The central vacuum unit will start to
work automatically.
If your installation incorporates retractable hoses, turn the system on by depres-
sing the switch on the retractable hose valve.
1. LED indicating that the unit is switched on.
2. LED indicating that the machine is in operation.
1. Connect the power cable (22). The "power" pilot on the LCD panel of the
DIGITAL model will be permanently lit indicating that it is connected to the power
supply. The central vacuum unit is now ready for use. Your appliance comes to
you from the factory already prepared. You do not need to set it up or make any
adjustments.
2. To prepare the hose for use, connect the telescopic wand and the appropriate
tool for the type of oor surface you wish to clean, to the hose handle.
3. Connect the hose to the system by inserting its cu into an inlet valve. Turn
the system on by sliding the switch on the low-voltage hose handle to the ON
position, assuming your central vacuum unit comes with this option. If not, the
system will automatically turn on when the hose is connected to the inlet valve.
For models with a low-voltage hose with a speed control facility, adjust this
according to the type of surface which you wish to vacuum.
If your installation incorporates retractable hoses, turn the system on by
depressing the switch on the retractable hose valve.
23
User guide