AVENLI RP2-21-CZ Benutzerhandbuch Seite 18

PROBLEM
Coloured After the first chlorine
treatment, the water
water
turns blue, brown or
Particles The water has a "milky"
suspended
in water
Permanently The pool probably leaks
low water
level
Algae The water has a green
tint. Green, brown or
black spots on the
surface of the pool. Pool
bottom is slippery
and/or unpleasant
The water in The water does not
the pool is
comfortable bathing
cold
Deformation
from the
frame
DESCRIPTION
black.
or cloudy colour.
water every day.
odour.
warm up to a
temperature.
CAUSE
Chlorine is oxidised with
minerals in the water.
This phenomenon
usually occurs when
water from different
sources is combined.
The "hard water" caused
the pH level to rise.
Insufficient chlorination.
Foreign contamination in
the water. Bathers not
cleaning their feet before
entering the pool.
A crack or hole in the
pool material. A crack or
hole in the filter pump
hose. Hose clamps too
loose. Evaporation in
high summer
temperatures.
Algae are present.
The pool is located in an
excessively shaded or
overgrown area. Heat
escapes from the pool
water
Not filled to the water
level.
18
ADJUSTMENT
Adjust to the recommended
pH value. Allow the filter to
run until the water is clear.
Clean the cartridge regularly
Adjust the pH value. Check
with your pool accessory
dealer for the correct water
treatment procedure.
Check that the chlorine level is
correct.
Clean or replace the filter.
Remove debris with a high-
pressure hose before
entering.
Locate the damage and repair
using the patch kit provided.
Repair or replace hoses.
Tighten all hose clamps. Cover
the pool when not in use.
Do the "shocking". Check the
pH and adjust to the
appropriate level as
recommended by your local
pool accessory dealer.
Vacuum or lightly scrub the
pool surface. Perform
frequent testing and maintain
proper chlorine levels.
Move the pool to an open
area with maximum exposure
to sunlight at peak times.
Keep the pool covered when
not in use
Continue filling with water up
to the water level.