Hama Big Zapper 2in1 Bedienungsanleitung Seite 16

7.4.2 CLEARING OF ALL LEARNED KEYS
1. Press and hold [MUTE] and [VOL+] keys for 3 seconds until the LED will be
lit.
2. Enter the code [9] [8] [2], the LED will flash
2 times and then remain on.
3. Press and release the [SETUP] key at the
Universal Remote Control. If the LED flashes 3 times, all commands have
been cleared successfully.
8. Maintenance
• Do not mix new and used batteries for powering the Universal Remote
Control, as old batteries tend to leak and may cause power drain.
• Do not use corrosive or abrasive cleaners on your Universal Remote Con-
trol.
• Keep the Universal Remote Control dust free by wiping it with a soft, dry
cloth.
9. Troubleshooting
Q. My Universal Remote Control does not work at all!
A. Check your TV/STB device. If the device's main switch is turned off, your
URC cannot operate your device.
A. Check whether your batteries are inserted properly and are in the correct
+/- position.
A. Check whether you have pressed the corresponding device mode key for
your device.
A. If the batteries are low, replace the batteries.
Q. If several Device Codes are listed under the brand of my TV/STB device,
how
can I select the correct Device Code?
A. To determine the correct Device Code for your TV/STB device, test the codes
one by one until most keys work properly.
Q. My TV/STB equipment responds only to some of the commands.
A. Try other codes until most keys work properly.
10. Service and Support
If you have questions on the product, you are welcome to contact Hama
Product Consulting.
Hotline: +49 9091 502-0
For further support information please visit:
www.hama.com
14