Lunos 5/UNI-RF Anleitung Seite 15

Decoupling of a Component (Slave)
To decouple a device, the master must still be in operation. For the
device that is to be decoupled (no master), the internal pushbutton
on the control must be pressed for 15 seconds.
The green LED starts flashing continuously at one-second intervals.
The successful decoupling of the device from the system or from
the master is confirmed by the red LED lighting up three times.
If the master is no longer in operation or if the master is to be de-
coupled, the component must be reset to factory settings. The pro-
cedure for this is described in the next section.
Reset to Factory Settings
To reset to factory settings (apart from the mechanical components
such as coding switches and DIP switches), the internal pushbutton
on the control must be pressed and held for 30 seconds.
Factory settings
White DIP-switch
Position 3
EN
EN
15