Tools Required For Assembly; Associated Documentation - Bergstrom DAF COOL ULTIMATE Montageanweisungen

DAF COOL ULTIMATE
wait at least 60 minutes after placing the unit in
horizontal position before it is started.
- Unit pre-charged with r-134a refrigerant gas.
- Important: When connecting the unit make sure
the polarities are not reversed. If this happens, the
control board will not switch on and the unit will
not operate.

Tools required for assembly

- Pneumatic saw.
- Spatula.
- Silicone gun.
- Suction cups for lifting the unit.
- Overhead crane or similar for lifting the unit.
- 13mm ratchet wrench
- 5mm Allen key
- Faston terminal crimper
Optional electrical installation kit
- Wiring connection in fuse box: 1003016503
Proper use of the product
- DAF Cool Ultimate is a roof-mounted air
conditioning unit suitable only for use in trucks.
It is not suitable for installation and operation in
agricultural or construction machinery subject to
intense vibrations.
- Non-intended use will void the unit's warranty and
exempts the manufacturer from any responsibility.
- If you are not sure how to use DAF Cool Ultimate,
read the product's user manual.
- If the temperature in your vehicle's cab is too
high for rest, first cool the cab with your vehicle's
air conditioning for a few minutes and then
run DAF Cool Ultimate to maintain the comfort
temperature.

Associated documentation

- Quick guide: 1002841526
- User manual: 1002841530
- List of spare parts: 1002841530
- Fault diagnosis: 1002841532
Dirna Bergstrom declares that the DAF Cool
Ultimate unit complies with the requirements of the
following EC Directives and that the harmonised
standards and technical specifications listed below
have been applied:
- EC Directive 2014/53/EU
- EC Directive 2011/65/EU
- EC Directive 2014/30/EU
17
EN