Operation; Cleaning And Storing - LIVARNO 1002-W Bedienungs- Und Sicherheitshinweise

must be countersunk so that the outdoor
spotlight can be fitted onto the wall bracket.
Switch the circuit-breaker for the circuit back
„
on or replace the fuse�
Setting the beam width
Tilt the outdoor spotlight to the desired
„
position (see Fig� H)�
z Operation
The outdoor spotlight is operated by means
of the three control knobs on the bottom end
of the light (see Fig. B).
Set the switch to position "I" to activate
„ 13
Always On mode� Set the switch
position "0" to activate Automatic mode
(motion sensor)� In this mode the following
settings are possible�
Setting the detection range
Turning the SENS control
„
increases the detection range so that the
motion sensor responds to movement as far
away as approx. 12m (see Fig. B).
Turning the SENS control
„
decreases the detection range so that the
motion sensor only responds to movement
as close as approx. 0.5m (see Fig. B).
Setting the burn time
Turning the TIME control
„
increases the illumination time (max�
1 minute) (see Fig. B).
Turning the TIME control
„
decreases the illumination time (min�
10 seconds) (see Fig. B).
Setting the sensitivity of the twilight
sensor
Turning the LUX control
„
increases the sensitivity so that the motion
36
GB/MT
to
13
clockwise
5
anticlockwise
5
clockwise
4
anticlockwise
4
clockwise
3
sensor will respond even in brighter
ambient light conditions (e�g� daylight) (see
Fig. B).
Turning the LUX control
„
decreases the sensitivity so that the motion
sensor will respond only in darker ambient
light conditions (e.g. at night) (see Fig. B).
z Cleaning and storing
RISK OF BURNS! The light becomes hot
„
when switched on�
Always allow the outdoor spotlight to
„
completely cool down before cleaning it�
SHORT-CIRCUIT RISK! Water penetrating
„
into the casing can potentially cause a
short circuit�
Before cleaning, remove the mains fuse or
„
switch off the circuit-breaker for the circuit to
isolate the outdoor spotlight from the mains
power supply� Use a voltage tester to check
that the outdoor spotlight is isolated from
the power supply�
Do not immerse the outdoor spotlight in
„
water�
Make sure that no water gets into the
„
casing�
RISK OF DAMAGE! Cleaning the outdoor
„
spotlight incorrectly can potentially cause
damage�
Do not use corrosive cleaning agents,
„
brushes with metal or nylon bristles or sharp
or metallic cleaning implements such as
knives, hard spatulas or the like� They may
damage the surfaces�
Do not use any chemicals for cleaning�
„
Switch off the circuit-breaker or remove the
„
fuse for the circuit�
Use a voltage tester to check that the
„
outdoor spotlight is isolated from the power
supply�
Allow the outdoor spotlight to completely
„
cool down�
Wipe down the outdoor spotlight with a
„
slightly moistened cloth� Allow all parts to
dry completely�
anticlockwise
3