Husqvarna 533RS Bedienungsanweisung Seite 53

Maintenance
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
Examine all cables and connections.
Examine the starter and the starter rope for damages.
Examine the spark plug. Refer to
Make sure that the bevel gear is filled to ¾ with grease.
Clean the external surface of the carburetor and the area around it.
Clean the spark plug. Remove the spark plug and do a check of the electrode
gap. Adjust the electrode gap or replace the spark plug if it is necessary. Refer
Technical data on page 58 . Make sure that the spark plug is assembled with
to
a supressor.
Examine the clutch, clutch springs and the clutch drum for wear. Replace if it is
necessary.
Replace the spark plug. Make sure that the spark plug is assembled with a
supressor.
Lubricate the drive shaft.
Make sure that the vibration damping units are not damaged.
Clean the cooling system of the product.
Clean the muffler.
To do a check of the muffler
WARNING:
has a defective muffler. Always replace a
defective muffler.
WARNING:
Mufflers with catalytic converters get very
hot during operation.
WARNING:
decreases the noise level and identifies
the exhaust gases from the operator. The
exhaust gases are hot and can contain
sparks.
CAUTION:
must be replaced if it is damaged. Do not
use a product if the spark arrester screen on
the muffler is missing or defective.
CAUTION:
is blocked, the product will be too hot.
This will cause damage to the cylinder and
piston.
1756 - 001 - 08.06.2022
To examine the spark plug on page 56 .
Do not use a product that
Risk of burn or fire.
Risk of fire. The muffler
The spark arrester screen
If the spark arrester screen
1. Make sure that the muffler is not damaged.
2. Make sure that the muffler is correctly attached to
the product.
To adjust the idle speed (533RS)
Your Husqvarna product is made to specifications that
decrease harmful emissions.
1. Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
2. Adjust the idle speed with the idle speed screw T
which is identified with "T" mark.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
53