Positioning The Sensor Wiring Harness - Abt AEC Montageanleitung

Mountinginstruction AEC for 2,0 BTD T6.1 EU6 AP
5 Positioning the Sensor Wiring
Harness
© 2021 ABT Sportsline GmbH
A Disconnect the rail sensor and
connect it to the ABT (rail
pressure) connector. Position the
wiring harness in such a way that
it is protected from abrasion and
away from heat.
B Connect the boost pressure
sensor 2 to the ABT (manifold
pressure) connector. Position the
wiring harness in such a way that
it is protected from abrasion and
away from heat.
C Disconnect the G1002 hall
sensor (camshaft position) and
connect it to the ABT (camshaft
position) connector. Position the
wiring harness in such a way that
it is protected from abrasion and
away from heat.
page 9/15