Technical Data - Meec tools 012442 Bedienungsanleitung

EN
REDUCTION OF NOISE
AND VIBRATIONS
• Plan the work so that exposure to heavy
vibrations is spread over a longer period.
• To reduce noise and vibrations when in
use, limit the time the tool is in use, and
use low-power/vibration mode and
suitable safety equipment.
• Take the following precautions to
minimise the risks of exposure to
vibrations and/or noise:
– Only use the tool in accordance with
these instructions.
– Check that the tool is in good
condition.
– Use accessories in good condition
and suitable for the purpose.
– Keep a firm grip on the handles/
grips.
– Maintain and lubricate the tool in
accordance with these instructions.
Symbols
The following symbols provide guidance for
how to use your power tool. Make sure you
understand the symbols and their significance.
Read the instructions.
Wear safety glasses and ear
protection.
Wear a dust filter mask.
Approved in accordance with
the relevant EU directives.
Recycle as electrical waste.
28

TECHNICAL DATA

Rated voltage
Stroke rate
Stroke length
Cutting capacity in wood
Cutting capacity in steel
Weight
Sound power level, L
wA
Sound pressure level, L
Vibration*, a h,B
Vibration**, a h,M
* Sawing in fibreboard. ** Sawing in sheet
metal.
Always wear ear protection.
The declared vibration value and noise, which
have been measured by a standardised test
method, can be used to compare different
tools with each other and for a preliminary
assessment of exposure. The measurement
values have been determined in accordance
with EN 62841-2-11.
WARNING!
The actual vibration and noise level when
using power tools may differ from the
specified maximum value, depending on
how the tool is used and the material. It
is therefore necessary to determine which
safety precautions are required to protect
the user, based on an estimate of exposure
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
DESCRIPTION
1. Start inhibitor
2. Power switch
3. Battery connection
4. Locking lever to angle the base plate
18 V DC
0 – 2500 spm
25.4 mm
54 mm
6 mm
1.73 kg
99 dB(A), K=3 dB
88 dB(A), K=3 dB
pA
3.327 m/s², K=1.5 m/s²
3.999 m/s², K=1.5 m/s²