BOMANN WA 7194 Bedienungsanleitung, Garantie Seite 36

Wash temperature
Select the temperature corresponding to the textiles
and pollution. Basically: the higher the temperature,
the higher the power consumption.
95°C : Heavily soiled pure white cotton or linen (e.g.
tablecloths, sheets and towels).
40°C_60°C : Moderately soiled colored cotton, linen
and synthetic (e.g. shirts or underwear). Slightly
soiled whites (e.g. underwear).
cold_20°C_30°C : Normally soiled laundry (including
synthetic and wool).
Capacity
Do not overload the appliance otherwise the laundry
is not getting clean. Refer to the information in the
"Program table"
.
Starting the program
 Connect the appliance to the power supply and
switch it on.
 The water supply must be opened to the maxi-
mum pressure.
 Load your laundry and fill in the detergent, if nec-
essary.
 Close the appliance door properly.
 Set the required washing conditions.
 Start the operation.
Door lock
Once a wash program has been started, the appli-
ance door cannot be opened.
When the wash cycle is finished, the door lock will
automatically be unlocked.
Refill laundry
WARNING:
Never attempt to force open the appliance door dur-
ing operation.
All manuals and user guides at all-guides.com
After the program has started, you can refill or re-
move laundry as needed. Interrupt the washing pro-
cess with the Start/Pause- button. The appliance
checks whether a refilling is possible and, if neces-
sary, releases the door lock after a short time.
As soon as the water temperature or the water level
exceeds a certain value, the door remains locked for
safety reasons and cannot be refilled.
Emergency door opening
If the appliance door cannot be opened due to a
power failure or other special circumstances, the
door locking lever at the drain pump can be used for
emergency opening.
Make sure that the appliance is disconnected from
the power supply and that the water temperature and
the water level are correspondingly low.
 Open the maintenance cover in the base of the
 Pull the locking lever (D) down with the help of a
Changing the program
 To change the program, first interrupt the washing
 Switch the device briefly off and then on again.
 Select the desired program and start the new
36
CAUTION:
unit. For this, the use of a tool could be neces-
sary.
tool while you operate the door handle at the
same time. Now the appliance door should be
open.
process.
operation.