Maintenance And Service; Maintenance And Cleaning - Bosch GOF 900 CE Professional Originalbetriebsanleitung

OBJ_BUCH-203-002.book Page 28 Tuesday, December 11, 2007 8:27 AM
28 | English
– Insert the centring pin 50 into the tool holder
as shown in the figure. Hand-tighten the
tightening nut so that the centring pin can
still be moved freely.
– Align the centring pin 50 and the guide bush-
ing 47 to each other by slightly moving the
guide plate 9.
– Tighten the pan head screws 48.
– Remove the centring pin 50 from the tool
holder.
– Push the release lever 22 and guide the
plunge router to the uppermost position.
For routing with the guide bushing 47 proceed
as follows:
– Guide the switched on power tool with the
guide bushing toward the template.
– Push the release lever 22 down and slowly
lower the plunge router until the adjusted
depth-of-cut is reached. Let go of the release
lever 22 again to lock this cutting depth.
– Guide the switched on power tool with the
protruding guide bushing alongside the tem-
plate applying lateral pressure.

Maintenance and Service

Maintenance and Cleaning

Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be de-
graded. The use of a stationary extraction
system is recommended in such cases as
well as frequently blowing out the ventila-
tion slots and installing a residual current
device (RCD).
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
2 610 956 208 | (11.12.07)
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
After-sales service and customer assist-
ance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer consultants answer your ques-
tions concerning best buy, application and ad-
justment of products and accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: SPT-Technical.de@de.bosch.com
Bosch Power Tools