Bosch GOF 900 CE Professional Originalbetriebsanleitung Seite 25

OBJ_BUCH-203-002.book Page 25 Tuesday, December 11, 2007 8:27 AM
Material
diameter (mm)
Hardwood
(Beech)
Softwood (Pine)
Particle Board
Plastics
Aluminium
After longer periods of working at low speed, al-
low the machine to cool down by running it for
approx. 3 minutes at maximum speed with no
load.
Switching On and Off
Adjust the depth-of-cut before switching on or
off; see Section "Adjusting the Depth-of-cut".
To start the machine, press the On/Off switch
24 and keep it depressed.
To lock the pressed On/Off switch 24, press the
lock-on button 2.
To switch off the machine, release the On/Off
switch 24 or when it is locked with the lock-on
button 2, briefly press the On/Off switch 24 and
then release it.
Constant Electronic Control
Constant electronic control holds the speed
constant at no-load and under load, and ensures
uniform working performance.
Soft Starting
The electronic soft starting feature limits the
torque upon switching on and increases the
working life of the motor.
Bosch Power Tools
Adjusting the Depth-of-cut
Router bit Thumb-
wheel 3 (see figure D)
4 – 10 5 – 6
12 – 20 3 – 4
22 – 40 1 – 2
4 – 10 5 – 6
For coarse adjustment of the depth-of-cut, pro-
12 – 20 3 – 6
ceed as follows:
22 – 40 1 – 3
– Place the machine with the router bit mount-
4 – 10 3 – 6
12 – 20 2 – 4
– Set the fine-adjustment path to the centre
22 – 40 1 – 3
4 – 15 2 – 3
16 – 40 1 – 2
4 – 15 1 – 2
16 – 40
1
– Set the step buffer 10 to the lowest position;
– Loosen the wing bolt for the depth stop 14
– Push the release lever 22 downward and
– Push the depth stop 15 downward until it
– Set the depth stop 15 to the required depth-
– Push the release lever 22 and guide the
The adjustment of the depth-of-cut may on-
ly be carried out when the router is
switched off.
ed on the workpiece to be machined.
position with the adjustment knob 20. For
this, turn the adjustment knob 20 until the
marks 21 match as shown in the figure. After-
wards, set the scale 19 to "0".
21
the step buffer engages noticeably.
so that the depth stop 15 can be moved free-
ly.
slowly lower the plunge router until the rout-
er bit 7 touches the surface of the workpiece.
Let go of the release lever 22 again to lock
this plunging depth.
rests on the step buffer 10. Set the slide with
the index mark 16 to the "0" position on the
scale for the depth-of-cut adjustment 18.
of-cut and tighten the wing bolt for the depth
stop 14. Pay attention not to misadjust the
slide with the index mark 16 again.
plunge router to the uppermost position.
2 610 956 208 | (11.12.07)
English | 25