Turning Off The Device - Geutebruck G-ST 2000+ Bedienungsanleitung

G-ST 2000+

Turning off the device

V 1.0
Serial port COM1 and COM2

At the COM1/COM2 port, there is a an RS-232 interface via 9-pin Sub-D sock-
ets RS-232.
Figure: COM1 and COM2
The 9-pin COM plugs are assigned by default as follows:
Figure: Pin assignment for COM connection – solder-side socket
Pin Function
1 JDCD
2 RxD
3 TxD
Turn off your G-ST in the following
1. Close all applications and click Start in the
2. Select shut down computer and press
The operating system will now shut down and all data will be
3. Then fully switch off your device by pressing the on/off button or by disconnect-
ing it from the power
Pin Function
4 DTR
5 Signal ground (GND)
6 DSR
order:
taskbar.
OK.
supply.
Back to the
table of contents
~
Pin Function
7 RTS
8 CTS
9 RI
stored.
21