Geutebruck G-ST 2000+ Bedienungsanleitung Seite 45

G-ST 2000+
Integrating the device into the network
It is best to have the following work performed by an
1.
2.
In general, when assigning an IP address, make sure that the assigned address is in
fact available and not already assigned to another network
16
5. By clicking on your country language and on Options you access the activa-
tion menu for the primary language.
6. Activate your language by clicking " Make this the primary language " and fol-
low the instructions.
Assign the G-ST the intended IP address in order to integrate it into the network.
Manual assignment of IP addresses is performed using the settings of the net-
work card of the device.
Using the console command PING, check whether the device was integrated
correctly into the network.
You start the command window by right-clicking on
Command Prompt  Enter PING + IP address.
Back to the
table of contents
administrator:
Start  Click on
component.
~
V 1.0