Turning On The Device - Geutebruck G-ST 2000+ Bedienungsanleitung

G-ST 2000+



Turning on the device

Before turning the unit on, please observe the following safety



Proceed as follows to switch on the device:
1.
2.
3.
4.
Enter the following at the MS windows Logon dialog box:
Then assign your own new password and write it down!
Be at least six characters in length.
Contain characters from three of the following four categories:
English uppercase characters (A through Z)
English lowercase characters (a through z)
Base 10 digits (0 through 9)
Non-alphabetic characters (for example, !, $, #, %)
Please note that this is the Windows system password, it is not possible
to recover the password if it has been lost!
14
Do not connect a cable shield to a ground connection (pin).
Keep the twisted part of the cable shield in the plug (socket) for as little time as
possible.
Use a socket with a protective contact to connect the power supply unit.
Ensure a power supply between 110 VAC and 230 VAC.
Please do not press any keys whilst powering up! The operating system is
precisely pre-configured for your device. By pressing a key during powering up,
this configuration could be adversely affected.
Connect the device to the power supply.
The device has been switched on.
Wait for the operating system to boot. During this operation, the client and the
database of the device are started
Use the key combination Ctrl + Alt + Del under
MS Windows an.
 User name: Administrator
Password: Pa$$w0rd

information.
automatically.
Back to the
table of contents
~
V 1.0