Digital Outputs - Geutebruck G-ST 2000+ Bedienungsanleitung

G-ST 2000+

Digital outputs

Each unit has 4 floating digital outputs. Like the digital inputs, these are distributed
onto the two 25-pin sub-D socket (relay 1-4).
Using the digital outputs, you can switch external devices, for example, to report sys-
tem errors. The respective events are created and set up accordingly in the G-Set
configuration software.
Assignment of 25-pin Sub-D connectors
ment of the 25-pin Sub-D connectors is shown in the following figure.
Figure: Assignment of the 25-pin Sub-D socket, solder-side
18
The contacts can be soldered directly to the corresponding Sub-D plug. The assign-
Connection
13
25
Normally closed contact
12
24
11 Normally closed contact
23
10
22 Normally closed contact
9
21
8 Normally closed contact
20
7 Ground
19
6
Ground
18
5
17
4 Ground
16
3
15
2
14
Ground
1
Changeo-
ver con-
tact
Signal
Normally open contact
Changeover contact
Normally open contact
Changeover contact
Normally open contact
Changeover contact
Normally open contact
Changeover contact
Switch input
Switch input
Switch input
Switch input
Switch input
Switch input
Ground
Switch input
Switch input
Back to the
table of contents
Normally open
contact
Normally
closed con-
tact
Socket 1
Relay 4
Relay 3
Relay 2
Relay 1
8
7
6
5
4
3
2
1
~
V 1.0