I Mportant Notes - Clearaudio concept Bedienungsanleitung

User manual / Bedienungsanleitung

4. I mportant notes

4.1 Adjustment of the tracking force
Never check or adjust the tracking force when there is a record on the platter.
Always remove the record first. The pre-adjusted and recommended tracking force for the Clearaudio
concept MM
cartridge is 2.2g and for the
4.2 Adjustment of the tonearm height
Since everything on the turntable is pre-assembled
and tested, including tonearm and cartridge, there
is usually no need to change any parameters on the
concept
turntable. I f you wish to change the height
of your tonearm, please refer to your nearest qualified
dealer or service personnel.
Your dealer can make the height adjustment by
loosening the locking screw on the side of the tonearm
base of your turntable.
Clearaudio assumes no liability for incorrect handling or any damage caused if non-qualified
persons attempt these adjustments.
4.3 Adjustment of the anti-skating force
Again, since everything on the turntable is pre-
assembled and tested, including tonearm and cartridge,
there is usually no need to change any of the
turntable parameters.
I f you wish to change your cartridge and to adjust the
anti-skating force, please refer to your nearest qualified
dealer or service personnel.
Your dealer will find the anti-skating adjuster on the
underside of the turntable.
Clearaudio assumes no liability for incorrect handling or any damage caused if non-qualified
persons attempt the above adjustments.
Made in Germany
Clearaudio concept mc
Pic. 9:
concept
Pic. 10:
cartridge is 2.2g (± 0.2g).
Adjustment of the tonearm height
Adjustment of the anti-skating
Page / Seit e 7