Operation; Adjusting The Motion Sensor; Adjusting The Signal Frequency - Parkside PTUS 1 A1 Bedienungs- Und Sicherheitshinweise

different consistency, check with a specialist to find out which
material is suitable for installation on your wall.
Ensure the screw
Allow the screw to protrude approx. 1 cm from the wall and
use the loop

Operation

The product has two adjustment options:

Adjusting the motion sensor

The sensitivity of the sensor can be adjusted using the sensitivity
controller . If a movement is detected, a signal / flash sounds /
2
shines approx. 30 sec. Adjust to MAX position, the detection range
approx. 8 m.

Adjusting the signal frequency

The product has 5 different programmes to repel certain kinds of
animals.
Adjust the frequency contoller
programme.
16 GB/IE/NI
is a maximum of 1.5 m above the ground.
15
to hang the product on the screw.
7
3
to select below frequency